Precautions for storage and restoration of motorcycles in winter

Motorcycle storage and maintenance

STEP O1

Completely replace the new oil of the corresponding brand, and lubricate the chain;

 STEP 02

Block the inlet of the air filter and the exhaust port of the muffler with a rag moistened with new oil to prevent moist air from entering the engine;

STEP 03

Take out the spark plug, inject 15~20ml of pure lubricating oil into the cylinder, and finally install the spark plug;

STEP 04

For motorcycles that have been stopped for more than a month, be sure to drain the fuel in the injector pipeline and inject anti-rust fluid;

STEP 05

Remove the battery, clean the surface of the battery with neutral soapy water, and clean the oxides on the positive and negative electrodes of the battery at the same time;

STEP 06

Store the battery indoors above 0°C and charge the battery once a month. The charging voltage does not exceed 12V, the charging current does not exceed 1.2A, and the charging time is 6 hours to 8 hours;

STEP 07

Adjust the tire pressure to the specified pressure, then put the motorcycle up, and the two wheels are off the ground;

STEP 08

Thoroughly clean the motorcycle, pay attention to wait for the engine and exhaust pipe to cool down when washing the car;

STEP 09

Spray rubber protective agent on the surface of rubber parts

STEP 10

The exterior parts of the whole vehicle should be coated with car protective wax;

STEP 11

Finally, cover the motorcycle with a dry cloth and park it in a dry and ventilated place.

Resume use

STEP 01

Remove the hood and scrub the motorcycle. If the car has been put on hold for more than four months, the lubricating oil should be changed;

STEP 02

Reinstall after charging the battery;

 STEP 03

Drain the anti-rust fluid in the fuel tank, and then add enough fuel;

STEP 04

Before driving, you must check carefully and test the car at low speed in a safe place.

(reprint)